Thermocouple temperature sensor for the glass industry
Weilian is a production temperature solution for the glass industry. Our products are constantly updated to meet challenging and changing glass production technology. We focus on custom design and engineering solutions.
Three -level thermocouple temperature sensor
The viscosity of the glass in the front wall of the container has an important impact on the flow and the weight of the empty area. Install the thermocouple through the front furnace, you can accurately monitor and control the glass temperature. Because the viscosity is related to the temperature, the glass flow is obtained.
For glass manufacturers, this precise control has many benefits:
The best weight of each container
Reduce fuel tank wear and extend the life of the fuel tank
By increasing the output of each batch of containers, save total costs
The melting glass is a harsh environment, and any heat -induction of it must be able to withstand bad conditions. The three -layer component is protected by ODS platinum or platinum/cymbal alloy to avoid the erosion of Gobeli, and there are three measurement points to measure the temperature at the top, middle and bottom, respectively. This allows precise control of heating and cooling to provide uniform glass flow.
Full welding design
Ceramic design
In order to adapt to the complexity of the control system, arrange along the front wall and span three levels. Each three -layer design to adapt to the personal front wall. Pay attention to optimize the expected life expectancy with the total cost of each assembly.
Typical front furnace arrangement
Three levels can be used below for calibration:-
/Category R (PT/PT 13% RH)
/S type (PT/PT 10% RH)
6 6 B type (PT6% RH/PT30% RH)
WeiLian uses fiber platinum at the R and three levels to improve the strength of the element and increase the overall assembly life.
Single glass thermocouple
Some application environments only need a single point measurement. The same design style can be used as a third level, but there is only one thermocouple knot. This connection point can be both at the bottom or other elevated points.
